جلد 9، شماره 4 - ( 7-1399 )                   جلد 9 شماره 4 صفحات 19-11 | برگشت به فهرست نسخه ها


XML Print


چکیده:   (1027 مشاهده)
Introduction: The objective of this study was to compare the Von-Mises-stress (VMS) distribution applied to the edentulous ridges from a Polyamide RPD (PRPD) with those from a Cobalt-Chrome RPD (CCRPD).
  Materials and Methods: A patient with mandibular Kennedy Class I, Mod I was
selected. The patient’s CBCT was cut off at 1 mm sections from the axial dimension. DICOM files were created. A three-dimensional-bone-model was prepared by
segmenting the DICOM files and loading them in MIMICS software and the necessary modifications were applied on them using Geomagic software. The three-dimensional-designs were first developed using Exocad2016 CAD software. An extensive force equivalent to 150N was applied. Abaqus Software was used in order to meshing.  Then the stresses applied on the left and right sides of the edentulous ridges were measured.
 Results: In both models, the highest distribution of VMS in the edentulous ridges was observed exactly distal to the abutment teeth adjunct to the distal-extension-areas. In CCRPD, the mean stress on the left-edentulous-ridge was 220kPa and on the right-edentulous-ridge was 100kPa. In PARPD, the mean stress on the left-side-edentulous-ridge was 950kPa and on the right-side-edentulous-ridge was 600kPa. The amount of stresses on the edentulous ridges in the PARPD model (form 280Pa to 950PA) were too much less than those of CCRPD model (from 50kPa to 220kPa).
Conclusion:The polyamide bases can be flexed due to the applied forces and the forces can be distributed in them. So that PRPD can transfer very slight stresses to the underneath surfaces compared to CCRPD.


 
متن کامل [PDF 713 kb]   (580 دریافت)    
نوع مطالعه: پژوهشي | موضوع مقاله: So on
دریافت: 1399/8/11 | پذیرش: 1399/10/9 | انتشار: 1399/10/9

بازنشر اطلاعات
Creative Commons License این مقاله تحت شرایط Creative Commons Attribution-NonCommercial 4.0 International License قابل بازنشر است.